Hikmicro M30 Guia De Inicio Rapido página 4

Note:
The warning sign is under the laser and on the left of the device.
Component
Navigation Button
Laser Button
Lens Sheet Button
Back Button
Focus Knob
Trigger
Cable Interface
3. Charge Device
After the device starts up, the OSD (on-screen display) shows the battery status. When the battery is low, charge
the device and ensure it works properly.
For the first charge, charge the device for more than 8 hours when the device is turned on.
Note：

The built-in cell battery that powers the real time clock (RTC) of the device may drain during longtime
transportation or storage. It is recommended to recharge the RTC battery for the wellfunctioning of the
device clock.
 To fully charge the RTC battery, the following requirements should be met:
a) The rechargeable lithium batteries should be installed on the device.
b) The device should keep working for more than 8 hours before shutting down.
3.1 Charge Device via Cable Interface
Steps
1. Lift the cover of interface.
2. Plug in the cable, and charge the device.
3.2 Charge Device via Charging Base
Steps:
1. Hold the device, and press both battery
lock catches of the device.
Menu Mode:
 Press , , , and  to select parameters.

Press OK to confirm.
Non-Menu Mode:
Press  to turn on/off the LED light supplement.

Press  to start digital zoom.

Hold the button to turn on laser, and release the button to turn off laser.
Cover the lens to perform the correction.
Exit the menu or return to previous menu.
Adjust lens focal length.
Pull the trigger to capture. Hold the trigger to record videos.
Charge the device or export files with supplied cable.
Function
4