Operating Instructions - TensCare Elise 2 Manual Del Usuario

11.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit on, press the
ON/OFF button and hold for 3 to
5 seconds until the display shows.
To turn the unit off, press the ON/OFF
button and hold for 3 to 5 seconds until
the display stops.
When switched on
automatically start in the programme
which was being used when it was last
switched off.
During start up to stop the increase in
strength at any time, press any key
once.
The unit will turn off automatically:
• When the Timer reaches zero,
• If it is left at zero strength for more
than 5 minutes.
Note: Always check unit is
OFF before
removing probe or pads.
STRENGTH CONTROLS
+
The buttons marked + and - are
the strength controls.
-
To increase strength, press and
hold down the button + until
required strength is achieved.
To decrease the strength, press and
release the button -.
To increase strength in steps of 0.5 mA,
press and release the button +.
The unit will remain in the WORK part
of the cycle for 5 seconds while
intensity is being adjusted.
the unit will
applying or
17
The strength levels are shown on the
LCD.
The strength control buttons will not
operate until the unit is properly
connected to you (probe inserted
correctly). Elise
disconnection and
returns the strength to zero.
The unit has levels of strength from 0 to
99.0 mA in steps of 00.5 mA. If you hold
down the button + for 3 to 5 seconds,
the strength will start scrolling.
You may feel nothing over the first few
presses. Continue pressing until the
sensation is strong but comfortable.
Further increases during use may be
necessary if your body becomes used
to the sensation.
PROGRAMME CONTROL
The button marked P is the
P
programme control. The Elise 2
has four pre-set programmes. At first
use, the unit automatically goes to
programme STRES. Next time it is
switched on, it will default to the
programme used last.
Each time you press and release the P
button, the programme changes and is
shown on the LCD.
Each time you change the programme,
the strength level reverts back to zero.
This is a safety feature to alleviate any
sudden feeling of a surge, as each
programme gives a different sensation.
2 detects a
automatically