Publicidad
securely connected to the Negative (-) battery terminal.
7. From the driver's area, attach the brake control's Black
"BATT" wire to the opposite end of the Black wire attached to the
"AUX" side of the circuit breaker using a yellow 10/12 ga. butt
connector or by soldering the leads together.
8. Attach the brake controls White "GND (-)" wire to the
opposite end of the White wire leading to the vehicles negative (-)
battery terminal using a yellow 10/12 ga. butt connector or by
soldering the leads together.
9A. For 1989-1991 Ford E & F-Series Trucks & Vans
with anti-lock brakes: (All other vehicles continue to Step 9B)
Locate the crescent shaped turn signal harness connector (fig. 1)
located on the steering column
under the dash. The connector will
have two rows of wires. A row of
four wires and a row of seven
wires. Attach the brake controls
Red "STLT" wire to the light green
wire (second in the row of seven) with a 14 ga. wire tap.
Caution: Do not connect to the Red wire with the Green
Stripe as serious damage may occur.
9B. For All Other Vehicles:
Locate the stop light switch on the back side of the vehicles brake
pedal. Determine which side of the switch is the "cold" or
switched side by probing the terminals of the switch with a test
light or current meter. The cold terminal will only indicate power
when the brake pedal is depressed. Connect the brake controls
Red "STLT" wire to the cold side of the stop light switch with a
14 ga. wire tap.
LIGHT GREEN WIRE
fig. 1
Publicidad
