Publicidad
10. Feed a length of 12 ga. Blue stranded wire from the brake
control to the trailer connector at the rear of the vehicle.
Caution: When passing wire through sheet metal,
always utilize an existing grommet, add a grommet or
use silicone rubber to insulate the wire from the hole.
11. Attach the brake controls Blue "BRAKE" wire to the Blue 12
Ga. wire using a 10/12 ga. butt connector.
12. At the rear of the vehicle, attach the Blue wire to the vehicle's
trailer connector brake terminal (see the connector's wiring
diagram for the correct terminal location).
13. Connect the wire from the "BATT" side of the circuit breaker
to the vehicle's positive (+) battery terminal.
Note: The Black "Battery" wire must be connected
directly to the tow vehicle's positive (+) battery terminal
via a self-resetting 30 amp circuit breaker. Do not
attempt to connect this wire to the vehicle's fuse panel
or other accessory wiring. Failure to connect directly to
the vehicle battery may damage vehicle wiring and
cause trailer brake failure.
Publicidad
