Vivreau PURITY C Quell ST Manual página 12

• The filter system must not be opened or dismantled during operation. The filter cartridge
must not be opened.
• Production date
Production code filter head – example: H 8375 01381
8 Production year, this example: 2018
37 Production week, this example: calendar week 37
5 Production day from Monday (1) to Sunday (7), this example: Friday
01381 Serial identification number
Production code filter cartridge – example: B8224350010
8 Production year, this example: 2018
22 Production week, this example: calendar week 22
4 Production day from Monday (1) to Sunday (7), this example: Thursday
35 Internal Identification No. of filter medium, this example No. 35
0010 Consecutive number of the filter cartridge, this example the tenth cartridge; reset when the day changes
3.5 Technical safety assembly instructions
• The appliance in which the filter is used must be free of limescale prior to installation.
• Protect the filter system from sunlight and mechanical damage. Do not assemble near sources
of heat and open flames.
• A stop valve must be installed before the filter system inlet hose.
• If the water pressure is higher than 8.6 bar (125 psi), a pressure reducer must be installed in
front of the filter system.
• When choosing the material for parts that come into contact with water after the VIVREAU filter sys-
tem, it is important to remember that, due to the process, decarbonised water contains free carbon
dioxide. For this reason, only materials that are compatible with free carbon dioxide must be used.
Note: The water is not decarbonised when using PURITY C AC filter cartridges.
EN • All parts must be installed in accordance with the country-specific guidelines on the installation of
drinking water facilities.
4 Installation
Caution: Prior to installation, read the technical data (Chapter 9) and the operating and safety
!
information (Chapter 3). After storage and transport below 0 °C (32 °F), the product must be stored
in the open original packaging for at least 24 hours before it is commissioned at the stated ambient
temperatures (Chapter 9) for operation.
4.1 Assembling the filter head, water connection
• Close the water intake and switch off the power supply to the end device.
A
• Fit the wall mounting bracket
!
B
hoses and dimensions of the accessories (e.g. VIVREAU FlowMeter). When using the wall
mount, install vertically only! The PURITY C1100 cannot be installed using the wall mounting
C
bracket.
• Fit the hoses to the water inlet "IN"
D
!
• When using PURITY C 0 – 70 % filter heads, check by-pass setting
factory) and if necessary adjust this setting to the local carbonate hardness ( chapter 4.2).
• Lock the filter head
12
Caution: When fitting the bracket, note the installation dimensions, bending radii of the
Caution: The max. tightening torque at the connections must not exceed 14 Nm!
in the wall mounting bracket
1
in the intended position.
5
and outlet "OUT"
4
5
on the filter head
3
(set to 30 % at the
10
.
.
1