Vivreau PURITY C Quell ST Manual página 14

6 By-pass and capacity tables
The capacity tables for the PURITY C filter systems are provided on pages 3–9. The capacities
shown in the capacity tables are based on German carbonate hardness and are not certified by NSF.
Note: The stated capacities were tested and calculated based on standard application and machine
conditions. This information may vary according to external influencing factors.
The PURITY C AC has a filter capacity of 10,000 litres, regardless of the carbonate hardness and
the by-pass set. All intake water is filtered.
7 Repair
Regularly check the filter system for leaks. Regularly check the hoses for kinks. Bent hoses must
be replaced.
The complete filter system must be replaced in rotation after a maximum of ten years. The hoses
must be replaced in rotation after a maximum of five years.
Caution: Before replacing filter systems or hoses, read the technical data (Chapter 9) and the
!
operating and safety information (Chapter 3).
Regularly clean the outside of the filter system with a soft, damp cloth.
Caution: Do not use any abrasive chemicals, cleaning solutions or astringent cleaning agents.
!
EN
8 Troubleshooting
8.1 No water flow
Cause:
Troubleshooting:
8.2 No or low water flow in spite of open water intake
Cause:
Troubleshooting:
Cause:
Troubleshooting:
8.3 Leak
Cause:
Troubleshooting:
14
Water intake closed.
Open the water intake at the upstream stop valve or by closing the locking
handle on the filter head
2
Mains pressure too low.
Check mains pressure. If the fault continues, check the filter system and filter
cartridge and replace if necessary.
Filter head not mounted in direction of flow.
Dismantle filter head and install in direction of flow (Chapter 4).
Screwed connections not fitted correctly.
Check mains pressure. Check all screwed connections and mount according
to Chapter 4. If the fault persists, replace filter system.
.
1