Hisense 12K BTU Instrucciones De Instalacion Y Uso página 11

Attach Side Curtains to Window
1.Pull the left-hand curtain out until it fits into the window channel.
2.Use a 1 /8"(3mm) drill bit to drill a starter hole through the
hole in the top rail.
3.Insert one of the 3/4"(20mm) screws through the left-hand
curtain and into the window sash.
A
B
C
Install Window Sash Seal and Safety Lock
1. Insert foam seal behind the top of the lower window
sash and against the glass of the upper window.
A
2. Attach right angle safety lock to top window sash
as shown .
3. If necessary, trim weather seals to needed length,
peel off protective backing, and use to plug any gaps.
.
A Window sash
B. Hole in side curtain
C.3/4" screw
B
A. T op of lower window sash
.
B Foam seal
safety lock
3/4" screw
Attach the EVA Foam (only applicable for E-star models)
1. Put one EVA Foam on the Curtain housing.In order
to minimize air leaks and ensure optimal insulation,
it is necessary to install the EVA Foam on the
Curtain housing.
After the unit is installed to the window, measure
the inner width of the side curtain as shown.
2. Remark a line on the EVA Foam according to less 1/8
(3mm) than the measured width in, then cut the EVA
Foam along the line.
3. Remove the backing from the EVA Foam.
Attach one EVA Foam on the Curtain housing, the side
with adhesive should facing the Curtain housing.
4. Repeat for the right-hand curtain.
A
B
9
Measure the inner width
of the side curtain
A
A . Curtain housing
B. EVA Foam
B