Dry-Vacuuming Instructions; Plug In The Twin Tt; Turn On The Twin Tt; Extend/Retract Telescopic Wand - Rotho TWINtt AQUAFILTER Manual Del Usuario

Dry-Vacuuming Instructions

Once you have prepared the filter and attached the desired accessories, you can plug in the TWIN TT,
turn it on, and begin vacuuming. Here are a few things you'll need to know how to do during normal
operation:

Plug In the TWIN TT

The TWIN TT's power cord is located on the rear of the device. To
extract the power cord, simply hold the plug and pull slowly until the
cable reaches the desired length.
Connect the plug to a grounded electrical outlet. For more informa-
tion about properly grounding the device, see Avoid the Risk of Elec-
tric Shock on page 5.

Turn On the TWIN TT

Extend/Retract Telescopic Wand

To make the telescopic wand longer or shorter, keep a firm grip on the suc-
tion hose handle. Place your other hand on the clamping device and move
the clamp up or down to the desired location. Release the clamping device to
lock the wand at its new length.

Mechanical suction power control

The suction power can also be adjusted by means of the mechanical suction power
controller (auxiliary air slide).
Auxiliary air slide closed = full suction power
Auxiliary air slide open = reduced suction power.
The auxiliary air slide must always be closed when using the electronic suction
power control system.
ROTHO TWIN TT AQUAFILTER User Manual
All manuals and user guides at all-guides.com
Use the One-Touch power button to turn the device on and off, as
well as to regulate suction strength.
To use the low-strength ECO-setting, press the One-Touch power
button briefly. The vacuum turns on and the LED above the power
button turns green.
For maximum suction strength, press and hold the One-Touch power
button. Do not release the button yet. The vacuum turns on and the
LED above the power button turns green, then yellow. Release the
button when the LED turns yellow.
17