Clean The Twin Tt; Remove The Casing Cover For Cleaning - Rotho TWINtt AQUAFILTER Manual Del Usuario

Clean the TWIN TT

You should clean the TWIN TT after each deep-cleaning or wet-vacuuming. Be sure to clean the
vacuum over a sink or other basin to keep your floor and carpets clean. To clean the TWIN TT, do the
following:
1. Empty any remaining cleaning solution from the solution tank. Rinse the solution tank.
2. Fill the solution tank with clean water and return it to
the TWIN TT. Then, operate the spray system briefly
over a sink as you would during deep-cleaning to
clean the system of solution.
3. Empty any remaining water from the solution tank.
4. Open the casing cover and remove the anti-splash
grid and recovery tank.
5. Remove large deposits of dirt and filth from the re-
covery tank to avoid clogging your sink or toilet. Dis-
pose of these deposits in a trash bag and empty the
remaining dirty water in the recovery tank into a sink
or toilet.
6. Remove all filters from the recovery tank and TWIN TT.
7. Remove all lint and deposits and thoroughly rinse the anti-splash grid, cleaning solution tank,
recovery tank, filters, suction hose, telescopic wand, and accessory nozzles in clean water. Do
not use soap or detergent and do not clean parts in a dishwasher.
8. Using a soft cloth, clean and dry the surfaces of the TWIN TT inside the casing cover and the
area usually occupied by the recovery tank. Do not use soap or detergent and do not place the
unit in a dishwasher.
9. Dry all components thoroughly. Damp parts can lead to the breeding of mildew, bacteria, and
fungus.
10.Return the foam filters to the Recovery Tank and TWIN TT and replace the recovery tank in the
TWIN TT.
Your TWIN TT is cleaned and ready for its next use.

Remove the Casing Cover for Cleaning

For your convenience during cleaning, you can remove the casing
cover. To remove the casing cover, open it and hold it upright. Pull
upwards until the hinge is freed from the hinge clip.
Do not try to over-extend the casing cover, as you may damage
the cover or the hinge.
To return the casing cover after cleaning, hold the cover upright
and press the hinge down into the hinge clip.
30
All manuals and user guides at all-guides.com
6
ROBERT THOMAS, L.P. ©2010
4