Machine Operation - Tennant 3220 Manual Del Operador

OPERATION
3. Pull and turn quick-release hook to remove power
cord (Figure 6).
4. Plug power cord into a grounded wall outlet
(Figure 7).
Grounded
3 Hole Outlet
Ground Pin
(120V)
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord.
6
All manuals and user guides at all-guides.com
FIG. 6
Grounded
Outlet
Grounding
Edge/hole
(230V)
FIG. 7

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Activate ON/OFF switch.
WARNING: Flammable materials can cause
an explosion or fire. Do not pick up.
2. Lower handle to operating position by stepping on
handle release latch (Figure 8).
NOTE: Brush motor will not start until handle is lowered.
3. Begin vacuuming floor. Operate machine with a
back and forth motion or "W" pattern.
4. To operate in the horizontal position, lower handle
to the stop point and step on release latch again
(Figure 9).
Upright
Position
FIG. 8
Operating
Position
Horizontal
Position
FIG. 9
Tennant 3220 (11- -99)