Controls - Snap-On EEWH312A Instrucciones De Funcionamiento

3.0 CONTROLS

6
1
2
3
Figure 8
Before operating the machine, take the time to famil-
iarize yourself with the operation and function of all
the controls.
A Press down and release the fi rst pedal (1) from
the left: the jaws of the turntable will retract. Do it
again: the jaws will expand. If you press the pedal
prior to the end of the stroke and release, the jaws
may be stopped in any position.
B Open the bead breaker arm. Press down and hold
the second pedal (2) from the left: by doing this
you operate the bead breaker blade and the arm
will move towards the machine. Release the pedal:
the bead breaker blade will retract.
WARNING!
ALWAYS KEEP ARMS AND LEGS AWAY FROM THE
BEAD BREAKER STROKE!
5
4
C
EN - 12
Press down the fi rst pedal (3) from the right: the turn-
table turns clockwise.
D Lower the Lock Lever (4) to unlock the vertical slide,
lift the Lock Lever to lock.
E Turn Swing Arm Adjustment Knob (5) for position-
ing mount/demount head slightly away from rim
diameter
F Press bead-seater pedal on left side of the machine
(6) half way down: air will come out from infl ation
hose end.
G Press bead-seater pedal (6) all the way down
swiftly to get air blast from the infl ator jets in the
clamping jaws. Air simultaneously comes out of
infl ator hose.
ATTENTION!
WHEN OPERATING THE BEAD SEATER IT IS
MANDATORY TO WEAR SAFETY GLASSES TO
PROTECT EYES.
Optional Safety Restraint Arm
H Safety Restraint Arm swings to center of the turn-
table.
I Lift upward on the restraint positioning knob to
position over tire/wheel assembly for inflation,
at the same time push down on the Anti-rotation
Lock Arm to release lock. You may now swing the
safety restraint arm to position on the center of the
wheel. Lower the restraint until the rubber pad on
the restraint disc is resting on the rim center. The
SRA is a gravity lock which will automatically lock
if any force other than the restraint
position knob is lifted. You are now
ready for the infl ation process.
not function until the safety arm is
centered over the turntable.
NOTE: the air supply will