Remote Control Button Operations - Toshiba RBC-SR1-PE Manual Del Usuario

All manuals and user guides at all-guides.com
AI R
EMOTE
R C
EMOTE ONTROL
1
MODE FAN CENTRAL
FAN ONLY AUTO OPERATION
COOL HIGH STANDBY
MED PREHEAT
HEAT LOW DEFROST
AUTO FILTER
TEMP CHECK LOUVER
UNIT MANUAL
˚ C
88
TIMER CONT. OFF ON ADDRESS
88 : 88
H M
9
1. MODE Button
Selects the desired operation mode. Each time it
is pressed, the display changes in the following
sequence:-
FAN ONLY COOL HEAT AUTO
2. FAN Button
Selects the desired fan speed mode. Each time it
is pressed, the display changes in the following
sequence:-
AUTO HIGH MED LOW
3. LOUVER Button
This is used to drive the outlet louvers
automatically when the air conditioner is in
operation. When it is pressed, the louvers will
start oscillation and the display will illuminate.
When it is pressed again, the louvers will stop.
4. TEMP ADJUST ( ) Buttons
These buttons are used to set the required room
temperatures (18-29°C).
5. TIMER Button
When the air conditioner is switched off, the operation lamp and LOUVER display go off, but the
other displays remain unchanged.
Use the CHECK button for a malfunction check. Do not operate this button under normal
GB
C
ONTROLLER
B O
UTTON PERATIONS
2 3
NETWORK
REMOTE CONTROLLER
4
MODE
- +
6
TIMER ADJUST
CHECK FILTER
5
ON/OFF
10 7 8
6. TIMER ADJUST Buttons
7. OPERATION Lamp
On initial power on or after a power interruption
this lamp will flash. This lamp is lit during normal
operation.
8. ON/OFF Button
When this button is pressed, the machine starts
or stops within a couple of minutes.
9. CHECK Button
10. FILTER Button
CHECK button and FILTER button are for the
use of service engineers.
CAUTION
– 5 – – 5 –