Ryobi TSS100L1 Manual Del Operador página 17

WARNING:
Make sure the spindle lock button is not engaged
before reconnecting saw into power source. Never
engage spindle lock button when blade is rotating.
DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
ALIGNING THE LASER GUIDE LINE
See Figure 16.
Lock the switch by installing a padlock (not included) through
the hole in the switch trigger and closing the shackle.
Draw a line on the workpiece. When the laser guide switch
is turned on it will generate a red
This line will let you see your mark and the laser guide line
at the same time, and will assist you in lining up the mark
for more accurate cutting of the workpiece.
Align the laser line and the mark with the blade at the
uppermost position. Once both lines are in alignment, do
not move the workpiece.
Remove the padlock then
source. Make several practice cuts on different styles and
thickness of material. Repeat the steps above as necessary.
Follow the directions below for using the laser guide:
Removing Your Mark:
Position the laser line near the left edge of your mark on the
work surface in order to remove the mark.
To Cut Your Mark:
Position the laser line near or over your mark on the work
surface in order to cut the mark.
To Leave Your Mark:
Position the laser line near the right edge of your mark on
the work surface in order to leave the mark.
After you have become familiar with using the laser guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning the laser line with your mark.
All manuals and user guides at all-guides.com
ASSEMBLY
line on the work surface.
plug the saw into the power
LASER
GUIDE
SWITCH
17 — English
LOCK TRIGGER PRIOR
TO ADJUSTING LASER
AVOID EXPOSURE:
LASER RADIATION EMITTED
FROM THIS APERTURE
RED
LINE
Fig. 16