Indications For Use; Troubleshooting - Therabody RecoveryAir JetBoots Manual

Indications for Use

RecoveryAir is indicated for the temporary relief of minor muscle aches and pains, and for the temporary increase in circulation to the treated areas in people who are in good health. RecoveryAir
simulates kneading and stroking of tissues by using an inflatable garment.
Note
• The pump is "multi-voltage" and can be used for travel.
• An appropriate socket adapter must be used in countries with incompatible wall outlets.
• Use only RecoveryAir garments with the RecoveryAir pump.
• When immediate garment deflation is necessary, disconnect the garment hose bundle from the pump to immediately deflate the air pressure in the garment.

Troubleshooting

Symptom
The pump is not working.
The Status Indicator is On in yellow
The pump starts working and stops immediately.
One garment inflates but the second one does not.
The pump stops working, the Status Indicator turns
On in yellow.
The pump works at a very low
pressure, regardless of the pressure set by the user.
An irregular noise.
Boots are not automatically paired.
Warranty
For full warranty information, please visit www.therabody.com/warranty. To request a copy of the warranty by mail, you may send a request to the following address:
Therabody - WarrantyAttn: Customer Service, 6100 Wilshire Blvd., Los Angeles, CA 90048
Please note, this is not a return address or a retail location. No products or packages will be accepted at this location.
Possible Cause
No electricity
DC power adapter
DC power adapter cable
Malfunction
The air cannot move through the garment hose.
The second garment does not receive air.
Hose is not connected properly to garment or pump,
or prong plug is not inserted into unused air outlet.
Defective garment
Internal malfunction
Pump transferring vibrations to a surface
Internal malfunction
Boots were not pre-paired.
Corrective Action
Inspect the electrical wall outlet.
Verify that the DC power adapter cable is connected to the DC adapter
socket on the console, and the DC power adapter is connected to the 100-
240 Volt wall outlet.
Examine the cable for any defects.
Contact Therabody.
Examine hoses for kinks, twists and folds.
Examine its hoses for kinks, twists and folds.
Examine and fasten all air connections. When treating only one limb, always
plug the unused air outlet with the prong plug provided with the pump. If all
air connections are OK and the problem persists, contact Therabody.
Replace garment and check again.
Contact Therabody.
Make sure the pump is standing evenly on all four of its bumpers.
Contact Therabody.
If your boots are not automatically paired, press the pressure and time
buttons at the same time and hold both for 5 seconds to enable the pairing
of the two boots.
EN
8