Appliance Overview - Glatz PALAZZO Style Instrucciones De Montaje Y Uso

Appliance overview

indirect
Struts
LED light
(optional) direct Radiant heater
Slide
Installation and operating
instructions
Crank
(Motor optional)
Remote Support tube cover
(optional)
Support tube
Open / close parasol
!
Operation of the parasol with cordless drill is prohibited.
Open the parasol
1. Remove any protective cover
(optional)
2. Release binding belt
4
3. Spread struts slightly outward
4. Align any heating elements
5. Open parasol by turning the crank (for
crank drive) or with the remote control
(for motor drive)
!
Do not leave the crank inserted to
5
prevent misuse.
Close parasol
1. Allow any heating elements to cool
down for at least 30 minutes
2. Close any heating elements
3. Release tensioning lever, close parasol
5
4. Pull out / wrap fabric segments
5. Apply binding belt
6. Apply protective cover if necessary
2
!
Only wrap / pack completely dry para-
sols. Damage caused by flapping, com-
3
pression and chafing must be avoided.
22 23
Controlling the light and heat
• To control the functions, tap the buttons
several times or keep them pressed down.
• You can mix white or coloured light to suit
your preference by using the appropriate
buttons.
• Light and heating only work when the parasol
Pilot light
is open.
touch on
White light direct > both > indirect > off*
Coloured light direct > both > indirect > off*
Light > > > > > > > > auto brighter / darker
colour
Radiant
direct > both > indirect > off*
heater
Motor Open / stop / close / stop sunshade
All lights**
direct > both > indirect > off
Lights / heating
All off without saving >
saved light scenario on
* The last setting will be saved
** Keep button 1 or 2 pressed down to change the colour temperature
Changing the battery on the remote control
• Always keep batteries out of the reach of children. If a battery is swallowed,
seek medical help immediately.
• In case of incorrect use, there is a risk of explosion.
• Always pack batteries when storing or disposing of them to prevent
discharge, ignition or damage.
• Always dispose of batteries properly in accordance with the current law.
1
Open cover
!
Do not lose screw, and carefully detach
cover.
2
CR 2430
Replace battery, close cover
!
Use battery type CR 2430 and ensure
that the polarity is correct! Tighten screw
again carefully.
Emergency closure / Restart
The motor drive is protected against overheating and ceases to function
if there is a danger of overload, for example if several opening and
closing manoeuvres have been carried out within a short time. Proper
functioning cannot be ensured again until the motor has cooled down
sufficiently (around 5 to 10 minutes). The emergency closure function is not
part of normal use and should only be carried out in an emergency.
1
press and hold
brighter / darker
Unlock motor drive
1.3
brighter / darker
1. Insert allen key
2. Turn allen key around 180° to the
3. Close sunshade manually
! Manual closure should preferably
be carried out by two people on the
1.2
supporting arm at the mast.
brighter / darker
Save current light-
ing scenario 2
Reset motor drive
1. Use the remote control to move the
! Wait until the motor switches itself
off after reaching the stop position.
3
Restart
1. Manually close sunshade completely
2. Insert allen key
3. Turn allen key around 180° to the left
3.1
4. Remove allen key
3.3
5. Check proper functioning using the
! After restart, be sure to carry out
the function test to ensure proper
functioning.
right and decouple drive
motor drive into the closed position
(end position)
and couple in the drive
remote control