Glatz PALAZZO Style Instrucciones De Montaje Y Uso página 13

What do you have to do if...
Problem Solution / tip
Parasol is difficult to open. Treat the frame with silicon spray from
time to time.
Sliding marks on the aluminium These are normal signs of wear and
frame. can be wiped off with a damp cloth.
LED light / heater does not work. Change the battery of the remote
control, check the power supply to the
parasol. Make sure that the parasol is
fully open.
LED light / heater do not re- Change the battery of the remote con-
spond to the remote control. trol, or reduce the distance between
the parasol and the remote.
Handling and maintenance
• Allow the parasol to dry when open to prevent the formation of mould and disco-
louration.
• A protective sleeve protects the parasol and will extend its service life.
• Only pull the protective sleeve over the dry parasol when it is dry.
• Do not clean the protective sleeve in the washing machine. Do not use chemi-
cals.
• Clean the parasol cover when needed with lukewarm water, fine detergents and
a sponge.
• Do not use any bleach or sharp objects, to avoid damage to the cover.
• Check the tightness of all screws from time to time and tighten them if neces-
sary.
• If the parasol is located in a highly exposed position, increased wear and tear
must be expected. In such cases we recommend more intensive care and main-
tenance.
• In most cases, defective parasols can be repaired by your GLATZ partner. Only
use original replacement parts FROM GLATZ.
• Wipe the radiant heater unit from time to time with a damp, non-abrasive cloth.
The radiant heater unit must not be immersed in liquids.
• The frame can be rubbed with water. The coating colors can be refreshed with
a car polish. Paint damage can be touched up with the paint repair kit available
from GLATZ.
Disassembly / Wintering
DANGER! DANGER OF TIPPING DANGER OF INJURY IF THE PARASOL TOP-
PLES OVER
1. Close and tie the parasol properly.
2. Dismantle the parasol in reverse mounting direction.
3. Store the parasol in lying position together with all accessories in a dry place.
CAUTION! Check the parasol for condition and proper function before using it
again. In case of deformations, cracks and wobbly connections, have the parasol
professionally revised.
24 25
Retensioning the parasol
When the parasol is half open. To extend the life and
provide optimum wind stability.
1. Loosen the threaded screw
2. Adjust the strut extension profile
2
3. Tighten the headless screw
1 3
Warranty
Please contact your GLATZ partner before returning the product. The
warranty on the parasol lasts for 24 months from the date of purchase. The
warranty expires in the following cases:
• External application of excessive force
• Inappropriate operation or maintenance of the parasol
• Damage arising from force majeure
The wind guarantee for an open parasol is limited. The maximum permissible
wind speeds always require a fixed anchorage in the ground. If there are
several parasols, a minimum distance of 25 cm must be maintained between
any two of them. Likewise, a minimum distance of 25 cm must be maintained
between the parasol and walls.
EC Conformity declaration
We, Glatz AG, Neuhofstrasse 12, CH-8500 Frauenfeld, SWITZERLAND,
hereby declare that this product complies with the directives of the European
Community. The applicable declarations of conformity can be found on our
Download area at www.glatz.com.
Disposal
This symbol on the product, accessories or packaging indicates
that the product must not be treated as unsorted domestic waste
but must be disposed of separately. Dispose of the product at a
designated recycling collection point. The disposal of electrical
and electronic equipment within the EU and in other European
countries is carried out through collection points that have systems for the
separate collection of electrical and electronic equipment.
By disposing of the product correctly, you will help to avoid possible envi-
ronmental and health hazards that may be caused by improper treatment of
waste equipment. Recycling materials helps to conserve natural resources. So
please do not dispose of old electrical or electronic equipment with unsorted
domestic waste.
The packaging is made of environmentally friendly materials that can be dis-
posed of at your local recycling facilities. By disposing of the product correctly,
you will help to avoid possible environmental and health hazards. The product
is made of metal and synthetic parts. End-of-life disposal must be carried out
in accordance with regional environmental and waste regulations.