Assembly and Usage
IMPORTANT NOTE: Please refer to the end of this manual for all photos
that are referenced in parentheses in the instructions below.
Unpacking the Product
• Remove everything from the box – Stand, High Chair/Booster seat, Tray with tray insert and
documents (not shown).
• Discard all packaging materials properly including plastic coverings.
• DO NOT allow children to play with any packaging materials.
Adult assembly is required for this product. No tools required.
Attaching High Chair Seat to Stand Mode (No. 1)
• Open the stand by rotating the rear legs toward the floor until they lock into place. (1)
• Make sure BOTH adjustable legs are locked in the lowest position. (2)
• Unfold the footrest by rotating it toward the front of the seat until it locks into place. (3)
• The high chair seat can be attached to the stand ONLY in one direction– facing forward. (4)
• Align the slots on each side of the high chair seat with the male brackets on the adjustable legs of
the stand. (5)
• Push the high chair seat down until it locks into place. (6)
• Ensure that the release buttons on BOTH sides of the adjustable legs are in the OUT position. (7)
• Pull up on the high chair seat to ensure it is secure.
Detaching the High Chair Seat
• To detach the high chair seat from the stand, press the release buttons on BOTH sides of the stand. (8)
• Grasp the high chair seat and pull it up off the adjustable legs. (9)
• For storage or travel, press in the release buttons on both sides of the footrest and rotate it to its
closed position. (10)
Installing/Removing and Operating the Tray
• To install the tray, press and hold down the release lever on the underside of the tray, then pull the
locking mechanism toward the front of the tray. (11)
• Insert the two posts into the slots on the side arms of the high chair. (12)
• Push the tray all the way back toward the seatback. (13)
• Release the locking mechanism and pull on the tray to ensure it is locked in place.
• The tray can be adjusted into two positions. Press and hold down the release lever, pull the locking
mechanism toward the front of the tray, then slide the tray to adjust it to the desired position. (14)
• Ensure that BOTH sides of the tray are located in the same position.
• Gently pull on the tray to ensure it is secure.
• To remove the tray, press and hold down the release lever, pull the locking mechanism toward the
front of the tray, then pull the tray away from the high chair.
• Use caution when installing or repositioning the tray while a child is in the high chair.
It is recommended that the high chair be used in the upright
position only by children capable of sitting upright unassisted.
6
I WARNING
I WARNING