Troubleshooting - Bunn-O-Matic HB Manual Del Usuario

NOTE: Our friendly Customer Service Group is ready to help at 1-800-352-2866 or online at www.bunn.com
problem suggestions
Brewer does
• Make sure coffeemaker is plugged into a working outlet.
not turn on
• Press the Brew button to begin brew and red light will illuminate.
Coffee is not
• Make sure coffeemaker is plugged into a working outlet.
brewing
• Make sure coffeemaker is filled with water. A minimum of 4 cups
(20oz) is
needed to begin brewing.
• Make sure coffeemaker clock is set.
• Press the Brew button to begin brew and red light will illuminate.
• Check to see if Auto-Start time was programmed accurately.
Brew time is
• Check Sprayhead holes for debris. Clean Sprayhead and perform
longer than
Maintenance, see instructions on page 5.
usual
Brew funnel
• Be sure Brew Funnel is properly inserted.
overflows
• Use BUNN paper filters – they are taller to prevent overflow.
• Be sure Sprayhead is in place.
Warmer plate
• Warmer Plate automatically shuts off after 2 hours. To shut off
stays on after
manually, push the Brew button (red light will turn off).
brewing
• To turn Warmer Plate back on, press & hold Brew button for 5 sec-
onds.
6
All manuals and user guides at all-guides.com

TROUBLESHOOTING

problem
Programmed
Auto-Start did
not work
'CLEAN'
indicator light
appears on
screen
Water drips
through prior
to completing
Heating
or before
programmed
time
Off taste is
detected
Error Code
EE:03
Brewer did not
brew all cups
suggestions
• Make sure AM/PM was accurately selected.
• Reprogram for Daylight Savings Time or a power outage if
needed.
• Make sure Auto-Start button is illuminated.
• Perform Maintenance, see instructions on page 5.
• To reset "CLEAN" indicator, press and hold "H" and "M" buttons
for
3 seconds during idle.
• Lime or mineral build-up may prevent the valve between the Top
Tank and Sprayhead from properly closing. Perform Maintenance,
see instructions on page 5.
• Perform Maintenance, see instructions on page 5.
• The coffeemaker did not detect water. Check the top tank to make
sure coffeemaker is filled with water.
• A minimum of 4 cups (20 oz) is needed to begin brewing.
• To reset, unplug, wait 5 seconds, and plug back into outlet.
• Approximately 2 oz of water is absorbed for every 1 oz of coffee.