Kunft KSM2612 Manual De Instrucciones página 11

2.2.4. Presser foot support configuration
1. as shown in fig. 1, lift the presser bar lifter [32] so to lift the presser
bar [18].
2. Screw off the presser set screw [19] with a screw driver.
3. Install the presser support [20] into the presser bar [18] by sliding
it bottom-up.
4. Screw the presser set screw [19] with a screw driver to fix the
presser support [20].
2.2.5. Installing and changing the presser foot
A. use the metal presser foot [37] for ordinary sewing:
1. Put the presser foot [37] under the presser support [20], aligning
the presser foot's axle [37] with the presser support's groove [20].
2. Place the presser bar lifter [32] downward and the axle of the
presser foot [37] will be installed automatically on the presser
support [20].
3. Presser foot [37] disassembly: slide the presser support's poke
button [33] and the lift presser bar lifter [32] inwards to remove the
presser foot [37].
• Use the zipper presser foot [39] for zipper sewing;
• The procedure of installing and disassembling the zipper presser
foot [39] is the same as for the metal presser foot [37].
• The following Figures show the installed zipper presser foot [39]
Maq-Costura-KSM2612-Manual-2.indd 11
sewing machine
• Use the button hole presser foot [38] for
button hole sewing;
• The procedure of installing and disassem-
bling the button hole presser foot [38] is the
same as for the metal presser foot [37]. fig. 1
above shows the installed button hole pres-
ser foot [38];
KSM2612
11
EN
18/02/19 18:34