Kunft KSM2612 Manual De Instrucciones página 12

2.2.6. Installing and changing the sewing needle
To extract and install the sewing needle, please turn the machine off
and comply with the following steps:
1. Turn the power off and rotate the hand wheel [27].
2. lift the needle bar [16] and sewing needle [17] to the height shown
in fig. 1. afterwards, rotate the hand wheel [27], and then stop it to
keep it in a static position.
3. unscrew counter clockwise to unscrew the thimble screw [14].
4. Take out the sewing needle [17] to be replaced.
5. Pass the sewing needle [17] through the thread guiding spring
2 [15] by sliding it bottom-up and insert the needle bar [16] to its
bottom. Then screw clockwise to screw the thimble screw.
6. make sure you install the sewing needle in place until it cannot
be inserted further in. To install a normal sewing needle [17] you
must insert 7.5 mm into the end of the needle bar [16] [as shown in
fig. 5]. otherwise, it will cause damage or skipped stitches.
Attention:
Pay attention to the following points during the installation of the
sewing needle:
1. make sure the sewing needle is in perfect conditions.
The sewing needles shown in fig. 1 below will cause problems:
Maq-Costura-KSM2612-Manual-2.indd 12
A: curved needle
B: blunt needles
C: needle with damaged pinpoint
12
18/02/19 18:34