Kunft KSM2612 Manual De Instrucciones página 14

9. Slide the thread through the thread guiding spring 2 [15] after
passing through the thimble ring [14], as shown in fig. 10.
10. Wrap the thread end through the thread guiding spring 2 [15] to
11. Threading can be assisted by the threader [45], as shown in fig.
Attention
1. make sure the thread passes through the thread clamp [9]. When
the thread passes through thread clamp [9], poke slightly the
thread clamp [9] to make sure there is no thread jamming.
2. It is strictly required to follow the steps above during threading.
2.2.8. Installing and extracting the Bobbin
1. lift the presser foot and hold the upper thread by hand with an
extraction length of about 10 cm, as shown in fig. 1.
2. extract the accessories box [25] from right to left, as shown in
fig. 2.
3. Take down the transparent cover [23], as
shown in fig. 3.
4. Put the bobbin [44] into the rotating
shuttle of the bobbin thread, as shown
in fig. 4.
Attention
make sure that when you put the bobbin, the direction of the thread
end is clockwise, as shown in the above Fig.
5. Pull out 10 cm of the thread end from the bobbin, as shown in
fig. 5.
Maq-Costura-KSM2612-Manual-2.indd 14
the pinhole of the sewing needle [17], as shown in fig. 11.
12. Thread the steel wire of the threader [45] and pass it through
the pinhole of the sewing needle [17]. Hold the thread end by
hand and pull back the threader [45]. The thread end will pass
through the pinhole of the sewing needle [17].
thread
14
18/02/19 18:34