Technical Data; Power Requirements - Truper MAX-20L Manual

Technical Data

Code
Description
Drive
Voltage
Speed &
strokes per minute
Rotation
Torque
IP Grade
Battery
Charger
MAX-20L
WARNING
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING

Power Requirements

WARNING Tools with double insulation are equipped with a polarized plug
(one prong is wider than the other). This plug will only fit in the right way into a
polarized outlet. If the plug cannot be introduced into the outlet, reverse the plug. If
it still doesn't fit, call a qualified electrician to install for you a polarized outlet. Do
not alter the plug in any way. Double insulation eliminates the need of both a
grounded third power cord with three prongs or a grounded power connection.
WARNING
When using an extension cable, verify the gauge is enough for
the power that your product needs. A lower gauge cable will cause voltage drop in the line, resulting in power loss and
overheating. The following table shows the right size to use depending on cable's length and the ampere capability shown in
the tool's nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
WARNING When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are especially designed
for operating outdoors and reduce the risk of electric shock.
Cordless Impact Wrench (with accessories) / Cordless Impact Wrench
Ion-Lithium 20 V
Input:
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
Before gaining access to the terminals all power sources should be disconnected.
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE
MAX-20L MAX-20LS
101403
1/2" keyless
20 V
0 - 1 800 RPM
0 - 2 100 RPM
0 - 2 700 RPM
Forward - Reverse
162 lb-ft 220 Nm
184 lb-ft 250 Nm
221 lb-ft 300 Nm
IP20
4 Ah | Charging time: 80 minutes approximately.
Voltage: 127 V
Frequency: 60 Hz
Current: 1.1 A
Power Cord Grips used in this product: Type "Y".
Tool Build Quality: Class III.
Charger tool build quality: Reinforced insulation.
Extension gauge
from 6 ft to 49 ft
18 AWG( * )
16 AWG
14 AWG
8 AWG
grounded
101407
0 - 2 520 BPM
0 - 2 940 BPM
0 - 3 780 BPM
Output: 21.5 V 3.5 A
Authorized Service Center.
| higher than 49 ft
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3