After Use - STERWINS 25EGT1-300.1 Manual

WARNING ! The trimming line will be thrown out! Danger of
injury especially for bystanders!
• Auto-feeding : With the product running, release on/off switch 2 to let it stop
completely. Press the lock off button 1 and on/off switch 2 to start the product.
NOTE : The line will extend about 8 mm with each stop and start until the line reach the
length of the knife. Do not stop and start frequently as the trimming line may auto-feed
unintentionally and cause a lot of line to be wasted.

4.6 AFTER USE

Switch the product off and let it cool down remove the plug from the mains. Check, clean and store the
product after remove the plug.
5. TRANSPORTATION
Transporting the machine may require that you meet certain requirements specific to your country. Please
make sure to respect them by contacting the authorities of your country, in order to respect them all.
the power plug from the socket. Let the machine cool for 2 hours outside before transport it.
temperature during transportation will never be out of temperature range given on chapter storage.
Protect the product from any heavy impact or strong vibrations which may occur during transportation
in vehicles. Secure the product to prevent it from slipping or falling over.
6. WINTERING
Follow all instructions given on chapter storage below. We recommend using the original package
for storage or covering the product with a suitable cloth or enclosure to protect it against dust.
7. STORAGE
Store the machine : Illustration 6.1
Pull the power plug from the socket. Let the machine cool for 2 hours outside before storing it.
Only store the machine in a clean, dry, ventilated place with a temperature range of 4°C to 24°C. Cover it
in order to provide added protection. We recommend using the original package for storage or covering
the product with a suitable cloth or enclosure to protect it against dust. Be sure to secure the unit while
transporting
Shutdown the power tool . Examine the unit thoroughly for worn, loose or damaged parts. Clean the unit
before storing. Do not expose the product to sunlight. Make sure the product is always protected from
cold and humidity.
8. MAINTENANCE
8.1 CLEANING
DANGER! Risk of injury due to electricshock.
Shutdown and disconnect the power tool before adjusting,
inspecting, cleaning or storing the product.
53
ES
PT
EN
Pull
Ensure