General Description; Mounting The Wddg Housing - Eneo VKC-1327A/WDDG1 Instrucciones De Manejo

2. General Description

• For ceiling and wall mounting
• Weatherproof and vandal-resistant design
• Clear Lexan Bubble with Inner Liner
• /3" CCD B/W or colour board camera with manual varifocal lens
• Automatic Shutter Control (AES)
• Automatic Gain Control (AGC)
• Back Light Compensation (BLC)
• Manual 3-axis Camera Adjustment
• Easy to mount for interior or exterior use
3. Mounting the WDDG1 Housing
Wall and ceiling mounting
Note
A
Screw holes
W
Back of housing
Note
G
Housing cap
Connection cable
K
Cable feed
All manuals and user guides at all-guides.com
W
G
The operational side of the camera is mounted in the housing.
Prepare the mounting site for installation.
Loosen the 4 Torx screws on the housing, but do not completely remove them, and
remove the cap.
Mark the position of the back of the housing W on the surface on which the device
is to be mounted. The screw holes A in the attached plate and/or on the back of the
housing W may be used as a template.
Fix the back of the housing W on the desired surface (plug and cross-head screws are
enclosed) and feed through the cable. /3" or /" opening.
When mounting on a ceiling, the camera must be installed within the housing.
Fasten housing cap G on the back of the housing.
After connecting the power supply and attaching the coaxial cable to an appropriate
monitor, the camera is operational.
Rubber washer for cable feed
3
Wall / ceiling
K
A