Initial Use; Operation - Beurer MG 206 HD-enjoy Manual De Instrucciones

Hand switch
1
2
3
4
5

6. Initial use

• Fasten the protective cover to the surface of the Shiatsu seat cover with the Velcro straps. It is also possible
to massage without the protective cover; this is generally found to be "harder".
• Position the seat cover upright on a suitable seating arrangement with seating surface and backrest (chair,
sofa, or similar). Ensure that the seat cover is supported over its entire area and has a sufficiently high
backrest.
• Use the flexible fastening straps and Velcro strips to secure the Shiatsu seat cover.
• Connect the device to the mains power supply.

7. Operation

Gently press your back against the massage device to start with. Then make sure that you are in a comfort-
able position before gradually shifting your weight onto the massage device.The massage must be pleasant
and relaxing at all times. Stop the massage or change your position or the contact pressure if you find it is
painful or unpleasant.
• Do not force any part of your body, in particular your fingers, between the rotating massage heads and
their mountings in the device.
• Sit comfortably and upright on the seat cover. Ensure you sit centered and such that the massage heads
can move to the left and right of your spinal column.
• Switch on the massage device with the
button.
The LED lamp indicates the massage region set.
• You can activate the heat function of the massage heads by pressing the heat button [6].
• The Shiatsu massage unit with rotating massage heads slowly moves upwards from the starting position
in the lowest region of the back and moves up and down in the massage region set. Application only at a
single point is not possible, as the rotational movement and the displacement up and down are coupled.
• The automatic switch-off function is activated with selection of the massage region and is preset to 15
minutes. You can set the automatic switch-off function to 5, 10 or 15 minutes by pressing the timer but-
ton. Please note that changing the timer setting makes the timer start to count again from the beginning.
To avoid overheating the device, select the maximum massage duration at the beginning of the massage
and do not change it again during the massage.
• Do not use the massage device for longer than 15 minutes and then allow it to cool. Using the device
for longer can over-stimulate the muscles and cause tension instead of relaxation. The massage can be
finished at any time by pressing the
return to the starting position at the lumbar region. This is indicated by the LED flashing. Once this position
is reached, the device switches off.
• Do not disconnect the device from the mains supply during operation. Always switch it off only once it has
reached the starting position at the bottom.
• Do not use the massage device for longer than 15 minutes and then allow it to cool. Using the device for
longer can over-stimulate the muscles and cause tension instead of relaxation.
6
7
button. Select the region you wish to massage with the A+B/A/B
button. Please note that on switching off, the massage heads first
1. Button
2. timer button (5 –10 –15 minutes)
3. A+B button (entire back massage)
4. A button (upper back massage)
5. B button (lower back massage)
6. heat button (heat)
7. demo button
13