Automatic Power Off - Elari EDS-001 Guia De Inicio Rapido

Automatic Power off

In order to save battery power, the headphones are turned off au-
tomatically if:
1. The headphones are not connected to the Bluetooth device for
more than 3 minutes;
2. One of the headphones is outside the Bluetooth range of a
smartphone, or it cannot connect to the other headphone or
smartphone for 3 minutes (for the left earpiece) or 5 minutes (for
the right earpiece);
3. The charge level of the earphone is low.
Replacement and Installation of ear cushions
For the most comfortable use and best sound, it is important to
choose the correct size of ear cushions. Try on all ear cushions and
determine the size that suits you best. To ensure the correct choice
of the ear cushions, try to speak loudly. Your voice in both ears
should sound muffled.
1. Holding an earbud, gently pull the edge of the installed ear cush-
ion and remove it from the earbud.
IMPORTANT: When installing, do not pull the ear cushion. It may rip.
2. Place the ear cushion on the latch groove located on the under-
side of the earbud.
All manuals and user guides at all-guides.com
10
3. Repeat this procedure for the second headphone.
IMPORTANT: To avoid damage to your hearing, do not use the
headphones without ear cushions.
Wearing the Headphones (Page 3)
Fix the ear cushions on your earbuds. Insert the Elari EarDrops
headphones, adjusting them so that they fit comfortably in the ear.
WARNING: to avoid impairment to hearing, use the headphones
at an average level that is comfortable for you. Before putting on
the headphones, turn down the device volume, and then gradually
increase it to the desired level of comfort.
Headphones LED Indicators
When charging the headphones in the case
Red light is continuously on
White light / LED off
When using headphones
Red light flashes (every 5 sec-
onds) in conjunction with the
voice alert "Battery is discharged"
Battery is charging
Headphone battery is charged
Low battery
11