Controls And Functions; Front Panel - FONESTAR FS-2601E Manual De Usuario

DESCRIPTION
- Monaural power amplifier, 700 W maximum, 600 W RMS with low impedance 4-8 Ω loudspeaker outputs
and high impedance 100 and 70 V lines. Suitable for PA and sound system applications.
- Balanced auxiliary line level signal input and bridge output, both with XLR and 6.3 mm stereo jack
connectors.
- Automatic compression function for the input signal, avoiding distortion in the output when the input
signal has high levels and automatically decreases the output signal if the temperature in the amp exceeds
certain limits.
- It also has LED indicators to see how the amp is operating and its status: LED power, temperature,
protection, signal peak and output signal indicators.
- Three temperature, output short circuit and overload protection circuits, are activated when an anomaly
is detected in its operation, cutting off the output to avoid damaging it.
- To equalize the output, the amp has a 3-band tone control.

CONTROLS AND FUNCTIONS

FRONT PANEL

1.- POWER: LED power indicator.
2.- Power switch: switches the power amp on and off.
3.- PROT: LED protection indicator. It lights up when amp protection is activated due to overload or
short-circuit. With protection activated the audio output is cut off.
1
4.- TEMP: LED temperature protection indicator. It lights up when protection due to excess temperature
inside the amp is activated. The audio output is cut off when the protection is activated.
5.- CLIP: LED signal peak indicator. It lights up when the distortion exceeds 0.5 % due to the output signal
being very high. If it only lights up a little or occasionally, the output volume must be reduced, in this
BREAKER
case the compression function is working. If the LED indicator stays alight continuously, it is due to the
input signal being very high and exceeding the compression function range; the input signal volume
POWER CONSUMPTION: 1,000 W
must be reduced.
6.- SIGNAL: LED output signal indicator. It lights up when the output is over 200 mV.
~ 230 V AC. 60 Hz FUSE: 6 A
7.- TREBLE: treble tone control ±12 dB.
8.- MID: mid tone control ±12 dB. 4
9.- BASS: bass tone control ±12 dB.
10.- MASTER: output volume control.
11.- Carrying handle.
12.- Holes for installation in a 2 U 19" rack.
PRÉAMPLIFICATEUR PREAMPLIFICADOR PREAMPLIFICADOR PREAMPLIFIER
1 2 3 4 5 6
2
OUTPUT
COM
FS-2601
POWER AMPLIFIER
4 x 90 W RMS
INPUT
PUSH
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: SHOCK HAZARD - DO NOT OPEN
RISK OF FIRE-REPLACE FUSE AS MARKED
5
MASTER
PROT
TREBLE
TEMP
MID
CLIP
BASS
SIGNAL
7 8 9 10
3
4 8 70 V 100 V
LINK
PUSH
6
BREAKER
POWER AMPLIFIER FS-2601E
11 12
7
PROT
TEMP