Intended Use; Safety Notes - BGS technic 6745 Manual De Instrucciones

COMPONENTS
1
M12 nut with washer
2
M12 spacer bolt
3 M12 nut with washer
4 Base plate
5 M20x1.5 spindle
6
Cover plate
7 Adaptor
8 Depth control with M8x16
mm screws
9 15 mm C-ring
10 35 mm C-ring
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third-parties.

INTENDED USE

This tool set serves the disassembly and assembly of the rear training arm bushings. Disassembly of
the trailing arm from the vehicle is not necessary.
The tool components included are suitable for the following vehicles:
Ford Mondeo (2007-), S-Max (2006-), Galaxy (2006-).
Volvo S60, S80, XC60, V70, XC70 (2006-) based on the Ford platform.

SAFETY NOTES

• Use the tool only for work it is intended for.
When lifting the vehicle, always use the lifting points intended by the vehicle manufacturer.
•
Before commencing work under the vehicle, always ensure that the vehicle is sufficiently
•
supported by axle stands or ramps. Put wedges under the wheels and make sure that the
handbrake has been applied.
When working, ensure for a safe and anti-slip stand.
•
• When working with this tool set, always wear gloves and safety glasses.
Make sure that the tool is mounted correctly.
•
Do not over tighten or apply excessive force to the spindle as this could otherwise damage the
•
tool as well as the component.
• The tool is not suitable for air impact wrenches. The use of an air Impact Wrench may lead to
the spindle bearing or other components rupturing. The fragments of the components flying
around may cause injuries.
• Always use a workshop manual for detailed instructions.
Always grease the spindle thread before using the tool.
•
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Trailing Arm Bushing Tool Set,
for Ford & Volvo
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 6745
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed