NZI Helmets Spyder III Manual De Usuario página 12

open position. Press the bolt with the notch of
the visor until the maximum displacement is
Fig. 8
GB
Fig. 10
reached, as shown by the yellow arrow of Fig
10. Keeping the pressure on the bolt, place the
mechanism part of the visor in the mechanism
part of the helmet, as shown by the red arrow
of Fig. 11. Release the pressure on the bolt
and turn the visor slightly towards its closed
12
O W N E R S
position. Repeat the procedure on the other
side. Open and close the visor several times
to confirm that the visor is correctly mounted.
COMFORT LINER
Your helmet has a detachable comfort liner.
You can easily take it out and clean it. Wash
it by hand with neutral soap, don't wring it out
and avoid exposing it to direct sunlight while
letting it dry.
Fig. 9
Comfort liner replacement
Removal:
It is recommended to remove the cheek pads
first. Pull the frontal part of the liner out of its
slot (Fig. 12); then pull the rear part out of its
slot (Fig 13).
Assembly:
Fig. 11
It is recommended to remove the cheek pads
first. Insert the frontal part of the comfort lin-
er into its slot; then insert the rear part of the
comfort padding into its slot. If necessary, use
a flat screwdriver (carefully).
M A N U A L