NZI Helmets Spyder III Manual De Usuario página 13

O W N E R S
Fig. 12
Chin air deflector.
This helmet includes an air deflector to reduce
wind pressure in the chin-neck zone and the
noise level in the helmet.
Removal:
Carefully pull the deflector until it is completely
out of its slot (Fig. 14).
Fig. 14
M A N U A L
Fig. 13
Fig. 15
Assembly:
It is recommended to remove the cheek pads
first. Insert the plastic part of the deflector
into its slot.
Side cheek pads GP-1.
Your helmet has especially designed cheek
pads to optimize comfort and the positional
stability of the helmet while riding.
Replacing the cheek pads.
Removal:
Pull out the cheek pad by its rear part (Fig. 15).
Never pull at the front part, by doing this you
can apply to much force and break the inner
protective liner.
Assembly:
Insert the front part of the cheek pad in its
place; then push the rear part into its place.
Cheek pad cleaning.
You can wash the comfort liner of the cheek
pads. Detach the Velcro and take the comfort
liner of. Wash it by hand with neutral soap,
don't wring it out and avoid exposing it to di-
GB
13