Installation Instructions - PYD Electrobombas MP Serie Manual De Instalación Y Mantenimiento

INSTRUCTIONS MANUAL AND MAINTENANCE
SERIE MP
DN INT (A)
MODEL
KW
Ø" 220V
(P
1
MP80
1 3,7 0,8
MP100 1 4,3 1,1
MP120 1 7,0
1,2

3. INSTALLATION INSTRUCTIONS

Before starting the pump:
- Make sure that the mains voltage and frequency are the same as on the rating plate.
- Make sure that the capacitor matches the pump motor requirements (for single-phase motors).
- Make sure that the pump is fully submerged (for submersible pumps).
- Check the direction of rotation.
- Never run the pump dry.
- Never change the position of the level switch set by the manufacturer.
It is recommended to install a pipe with a larger diameter than the pump drive to reduce friction
losses as much as possible.
Install a check valve at the pump outlet to prevent the pipe from draining every time the pump
stops. Avoid bends and turns in the piping and ensure a correct connection between the piping
and the pump drive. Both cases affect the correct operation and performance of the pump.
www.proindecsa.com / proindecsa@proindecsa.com
3
m
l/min
POWER
CON
KW Hp
µF
) (P ) (P )
2 2
0,55 0,75 16
0,75 1,00 20
0,90 1,20
20
MODELO A
MP80 177 382
MP100 200 405
MP120
223 428
FLOW
/h
0 0,6 1,2 1,8
0 10 20 30
LOADING HEIGHT IN METRES
33 32 30,5 28,5
44 42 40 37
55 52 49 46
B C D E Kg
165 175 150 8
165 175 150 9
165 175 150 10
9
2,4 3,0 3,6 4,2 4,8
40 50 60 70 80
26 23 19,5 15,5 11
34 30 25,5 20,5 15
42 38 33 27 20,5 13,5
ENG
5,4 6
90 100
9
5