Conditions Of Use - PYD Electrobombas MP Serie Manual De Instalación Y Mantenimiento

INSTRUCTIONS MANUAL AND MAINTENANCE
SERIE MP
ENG
1. WARNINGS
The appliance may only be used after the instructions in the following document have been read
and understood.
- The appliance is not intended for use by children or persons with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervi-
sion or instruction concerning use of the appliance in a safe way and understand the potential
hazards involved.
Children should not play with the appliance.
- Cleaning and maintenance of the machine must only be carried out by adults and only after the
machine has been disconnected from the electrical power supply.
- The appliance must be powered by a properly protected power supply system.
- The company reserves the right to make any modifi cations to the machines described without
prior notice.
- Disconnect the equipment from the mains before any intervention.
- When the pump is running, there must be no particles in the water (clean water only).
- Do not use the pump without a residual current device.
- The pump must be operated with a 220 V - 240 V power supply, as indicated on the nameplate.
- Do not use the power cable to transport the pump or to unplug it.
- Make sure that the electrical connections are protected from moisture.
- Avoid dry running of the pump. Never use the pump if the suction hose is clogged.
- It is strictly forbidden to pump corrosive, easily combustible, aggressive or explosive liquids
(such as petrol, oil or nitro thinner), salt water and foodstuffs.
- The temperature of the liquid must not exceed 35°C.
- Do not use the pump if the safety devices are damaged or exhausted. Never disable the safety
devices.
The pump must be used only for the prescribed purpose. Any use other than those mentioned in
this manual will be considered a case of misuse.

2. CONDITIONS OF USE

The pump is designed for domestic water supply, garden sprinklers, etc. The PH for stainless steel
pumps is 2 ~ 13, but for cast iron pumps it is 4 ~ 10. The performance of the electric pump must
comply with the technical parameter marked on the nameplate.
The pump must not be used in the following situations:
- Temperature of the water > 35°C.
- Dirty water with particles.
- Corrosive, easily combustible, aggressive or explosive liquids (such as petrol, petroleum or nitro
thinner), salt water, oils and greases must not be pumped.
Specifi cations:
www.proindecsa.com / proindecsa@proindecsa.com
8