Troubleshooting; Troubleshooting Schedule - Husqvarna R 316TX Manual De Usuario

1. Remove the 2 screws that hold the belt shield and lift
it off.

Troubleshooting schedule

If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
Problem
The starter motor does not turn
the engine over
The engine does not start when
the start motor turns the engine
over
The engine does not run
smoothly
104

Troubleshooting

Cause
The parking brake is not applied. See
page 93 .
The lift lever for the cutting deck is in mow position. See
ting deck on page 91 .
The main fuse is blown. See
The ignition lock is defective.
The connection between the cable and the battery is bad. See
page 87 .
The battery is too weak. See
The starter motor is defective.
There is no fuel in the fuel tank. See
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
2. Lubricate with a grease gun through the nipple at the
right side, below the lower belt pulley. Lubricate until
grease is pushed out of the rear side of the nipple.
3. Attach the belt shield and tighten the 2 screws.
To apply and release the parking brake on
To replace the main fuse on page 98 .
To charge the battery on page 98 .
To fill fuel on page 90 .
To clean and change the air filter on page 97 .
To lift and lower the cut-
Battery safety on
844 - 002 -