Led Diagnostics; Blower Status; Charge Status; Assembling The Blower - Stihl BGA 45 Manual De Instrucciones

English
► Push the connector (4) into the blower's charging
socket (5) until it stops.
The LEDs on the blower (6) glow green during charging
and show the state of charge.
When the LEDs on the blower go out, the charging
process is complete and the charger will shut itself off.
► Remove the charger from the blower and disconnect the
charger plug from the wall outlet when charging is
complete.
A new blower is not fully charged. STIHL recommends that
you fully charge the blower before using it for the first time.
Operate the charger only indoors, in dry rooms and within an
ambient temperature range of 32 °F to 104 °F (0 °C to
40 °C).
The blower heats up during operation. The charging process
begins only after the blower and its integrated battery have
cooled down sufficiently.
Charging time depends on a number of factors, including the
condition of the integrated battery and the ambient
temperature. For a complete list of approximate charging
times, see www.stihl.com/charging-times.
Operation of the blower is disabled during charging and any
time the blower is connected to the charger.

11 LED Diagnostics

11.1 Blower Status

LEDs on the blower show the status of the power tool and its
integrated battery.
If three LEDs glow red continuously: the integrated battery
is either too hot or too cold. Allow the blower to warm up or
cool down gradually at an ambient temperature of about
50 °F to 68 °F (10 °C to 20 °C).
If three LEDs flash red when you activate the trigger switch:
the blower has an electrical malfunction. Do not operate or
charge the blower. Have it checked by an authorized STIHL
servicing dealer before use or storage.
16
For troubleshooting information, @ 22.

11.2 Charge Status

The LEDs also show the blower's state of charge.
To determine the blower's state of charge:
1
► Press the push button (1) on the blower.
The LEDs on the blower will glow or flash green for about
5 seconds and indicate the state of charge (see
illustration).
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20 % charge.

12 Assembling the Blower

12.1 Mounting the Blower Tube and Nozzle

WARNING
Make sure the activation key is removed before starting
assembly. Never operate your blower without a properly
mounted blower tube and nozzle, @ 5.7.4. Use only
attachments supplied or expressly approved by STIHL,
@ 5.5.
11 LED Diagnostics
80-100%
60-80%
40-60%
20-40%
0-20%
0458-719-8621-A