Preparing The Fan Site; Installing The Hanger Bracket; Assembling And Hanging The Fan - Create FLOWOOD STYLANCE Manual Del Usuario

PRE PAR I N G THE FAN SI T E
Choose the suspension bar that best suits your situation: it has a 15 cm and a 25 cm suspen-
sion bar.
Remove the bar bolt, removing the pin, and pass the canopy (roof trim) and the engine can-
opy through the suspension bar. Next, route the fan motor cables through the inside of the
suspension bar. Tighten the suspension bar to the engine and insert the bolt and pin.
Standard
mounting style
Standard Mounting hangs from the ceil-
ing by a downrod.
INSTAL LIN G THE HANGE R B R ACKE T
Please, drill an 8 mm in diametre hole on the concrete ceiling, and insert the bolt. Then, align
the bracket with the hole and tighten with a nut.
AS SE M B LI N G AND H ANGI NG T H E FAN
Cotter pin
E NGL I SH
8
Support brace
Angled Mounting recommended for a
vaulted or angled ceiling.
Wood ceiling
Cotter pin
20° 20° 20° 20°
Angled
mounting
style
Support
brace
Concrete ceiling
Electrical wiring
Canopy
Hanging ball slot
Decorative cover
Bolt
Adapter
Fixing screw