Remote Control Connection; Remote Control - Create FLOWOOD STYLANCE Manual Del Usuario

Tip: To prepare for threading electrical wires through the downrod, apply a small piece of
electrical tape to the ends of the electrical wires. This will keep the wires together when
threading them through the downrod.
• Loosen the fixing screws and nut at the top of the motor housing. Remove the pin and bolt
from the downrod (if you have not already done so). Slide the downrod through the canopy.
• Tread electrical wires through the downrod and pull extra wire slack from the upper end
of the downrod.
• Place the downrod into the motor housing yoke and reinsert the pin and bolt that were
previously removed. Tighten the fixing screws and nut securely.
• Lower the canopy to the motor housing.
1. **Light
2. **Light intensity control
3. Fan intensity control
4. Timer
5. Batteries (2 x AAA)
6. **Colour temperature control
7. ON / OFF button
** Function only available when having
the LED plate installed.
RE MO TE CONT RO L CO NNECT I O N
Make the connection between the receiver cables and the fan motor cables following the
color indications. Make sure the connection is tight.
Ground wire
AC L
N
Remote control receiver placement:

REMOTE CONTROL

Light L
Remote
Input L
Fan L
control
Neutral N
receiver
Input N
1
2
3
4
5
6
7
Ground wire
Light L
Motor L
Neutral N
E NGLI SH
9