Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
⇒ if the mode was set successfully the phone rings once.
⓳② Only national numbers and no emergency calls
This mode only allows the use of national phone numbers. The emergency numbers
112, 110 and 911 are not allowed. Short dials as set in ❾ only work if they are na-
tional numbers. To enable this mode, pick up the receiver and dial:
Format:
*00#2#<PIN>*
Example:
to enable mode 2 and set the 4-digit PIN to 1234: *00#2#1234*
⇒ if the mode was set successfully the phone rings once.
⓳③ Immediate dial of one number on pick-up
This mode automatically dials the quick-dial programmed as *1 (see ❾ ) as soon as
the receiver is picked up. All dial inputs are ignored. Incoming calls can still be an-
swered by picking up the receiver when the phone rings. To enable this mode, pick up
the receiver and dial:
Format:
*00#3#<PIN>*
Example:
to enable mode 3 and set the 4-digit PIN to 1234: *00#2#1234*
⇒ if the mode was set successfully the phone rings once.
⓳⓪ Disabling special modes
The special modes ⓳① and ⓳② can be disabled at any time by picking up the
receiver and dialling:
Format:
*00#0#<PIN>*
Example:
if your chosen PIN was 1234: *00#0#1234*
⇒ if special modes were disabled and normal operation is again ac-
tive the phone rings once.
IMPORTANT: Special mode ⓳③ cannot be disabled this easily, because picking up
the receiver will always lead to dialling short dial *1. To end this mode, please switch
off the telephone. For the 60s mobile 4G then rotate the dial disc to the 1 position and
hold it there, for the PushMeFon mobile 4G press and hold both # and *. Now switch
on the telephone (still holding the dial disc or pressing the buttons) and wait for about
30 seconds. Now you can disable this special mode in the same way as described for
⓳① and ⓳② above.
List of all commands
Command
*01#<local area code>* *01#01234*
Example
8
Function
Enter/Change a local area code
Publicidad
Tabla de contenido
