Makita GTR01 Manual De Instrucciones página 20

Using the tool with the plunge base
Always hold the grips firmly with both hands during opera-
tion. Operate the tool in the same way as the trimmer base.
Using the straight guide
Optional accessory
1. Install the straight guide to the guide holder by tight-
ening the wing nut. Insert the guide holder into the holes in
the plunge base, and then tighten the wing bolts.
Fig.65
► 1. Wing bolt 2. Guide holder 3. Wing nut 4. Straight
guide
2.
Loosen the wing nut on the straight guide and
adjust the distance between the trimmer bit and the
straight guide. At the desired distance, tighten the wing
nut.
Fig.66
► 1. Wing nut
3. Operate the tool in the same way as the straight
guide for the trimmer base.
Fig.67
1
2
3
4
1
20 ENGLISH
Using the templet guide
Optional accessory
1. Loosen the screws on the base and remove them.
Place the templet guide on the base, and then tighten
the screws.
1
Fig.68
► 1. Screw 2. Templet guide
2. Operate the tool in the same way as the templet
guide for the trimmer base.
Fig.69
Using the parallel ruler
The parallel ruler is effectively used for straight cuts
when chamfering or grooving. Adjust the distance
between the trimmer bit and the parallel ruler. At the
desired distance, tighten the wing bolts to secure the
parallel ruler. When cutting, move the tool with the
parallel ruler flush with the side of the workpiece.
Fig.70
2