Hydraulic Installation - Frigidaire LT15Y Manual De Instrucciones

Blackout
Occasionally there may be blackouts due to
thunderstorms or other causes. Unplug the
power cord from the electric socket when there
is a blackout. Once power is restored, plug the
power cord into the electroc socket. If the blackout
is extended for a long period, clean the washer
before reuse.

Hydraulic Installation

Water inlet hose (1)
Attach the end of the hose that comes loose on
faucet, so it is fully threaded (2).
Open the faucet and check for leaks.
The use of low quality faucet will damage the hose
of your washing machine causing water leakages.
IMPORTANT
The hose is provided with a filter that difficult
the entry of dirt that may come through the
water supply lines.
Do not connect the hot water hose (hot
water label) in the cold water faucet of your
residence.
Drain hose (3)
Place the hose in the drain outlet or at the edge of
the laundry sink (4) with a maximum height of 140
cm and a minimum of 90 cm for the proper operation
of your washing machine.
Place the hose into the tube in a maximum of 20
cm in the drain outlet.
When putting the hose on the edge of the laundry
sink, make sure the hose end is not submerged
in water tank, because the water can return to the
inside of the washing machine.
Never attach the drain hose in another hose to
increase the length; it may damage the internal
system water outlet.
All manuals and user guides at all-guides.com
Water pressure
To ensure a proper filling pressure, there must be a
minimum height of 2,4 m between the base of the
waterbox and the washing machine inlet.
Note: The inlet water pressure should be between
0.02 and 0.8 MPa. If the pressure is higher, use a
pressure reducer.
Do not use hot water higher than 50°C.
23