Preparation; Assembly Of The Meat Grinder; Assembly Of The Sausage Attachment; Mounting Of The "Kebbe" Attachment - Clatronic FW 3151 Manual De Instrucciones

Preparation

Please see the overviews on pages 3 and 4.
1. Open the fixture for the spiral housing with the screw (6)
on the appliance.
2. Place the spiral housing (7) with the filler neck facing up-
wards into the spiral drive and turn the screw clockwise
until it is closed.
3. Place the filling tray on to the filler neck in such a way
that the fixture for the tray is above the motor block.
4. Push the spiral (8) into the horizontal section of the spiral
housing.
Assembly of the accessories is described by the following
sections. Prepare the mincer according to your require-
ments.

Assembly of the Meat Grinder

• Please also observe our illustrations under "A" (page 4).
• Please follow points 1 to 4 as described under "Prepa-
ration".
5. Insert the knife with the sharpened edge outwards onto
the shaft of the scroll.
6. Select a perforated disc (10). Use the recesses to do so.
7. Rotate the catch clockwise.
More details can be found under "Electrical connection" &
"Operation".

Assembly of the Sausage Attachment

• Please also observe our illustrations under "B" (page 4).
• First proceed as described under "Preparation" and
"Assembly of the Meat Grinder", points 1 to 6.
7. Position the sausage attachment on the spiral housing.
8. Rotate the catch clockwise.
More details can be found under "Electrical connection" &
"Operation".

Mounting of the "Kebbe" Attachment

• Please also observe our illustrations under "C" (page 4).
• Please follow points 1 to 4 as described under "Prepa-
ration".
5. Position the 2-piece Kebbe attachment on the shaft of
the spiral. Use the recesses to do so.
6. Rotate the catch clockwise.
More details can be found under "Electrical connection" &
"Operation".
FW3151_IM_new

Assembly of the Cookie Attachment

NOTE:
You can shape different forms with this attachment after
preparing a cookie dough. This is particularly suitable for
so-called "Spritzgebäck" (cookies).
• Please also observe our illustrations under "D" (page 4).
• Please follow points 1 to 4 as described under "Prepa-
ration".
7. First, insert the disc onto the extension of the scroll shaft.
8. Then mount the shaping disc.
9. Rotate the catch clockwise.
More details can be found under "Electrical connection" &
"Operation".

Electrical Connection

1. Check whether the mains voltage that you want to use,
corresponds with that of the appliance. You will find the
information about it on the rating plate.
2. Ensure that the switch is set to "OFF" (Off).
3. Only connect the appliance to a properly installed safety
socket.

Switch Functions

Function Switch I / II (On / Return)
Use the function switch (4) to select the desired operating
mode for the switch (3).
Switch ON / OFF / R (Forward / Off / Return)
The appliance is equipped with a forward and return
function. If the scroll should block, you can use the return
function, in order to release it.
- Forward
• Turn the function switch (4) to "I".
• Turn the switch (3) to "ON". The appliance is in the
"forward" mode.
- Return
• Turn the switch (3) to "OFF" and wait until the motor
stops.
• Turn the function switch (4) to "II". Press "R" on the
switch (3). The appliance will be in the "return" mode
as long as you keep the switch pressed down.
- Switching Off
• Move the switch (3) to "OFF" and pull the power plug.
39
24.08.21