Measupro BPM-A70 Manual De Instrucciones página 7

• Slide the battery cover off.
• Insert 4 x AAA batteries (included) with correct polarity.
• Replace the cover.
• This unit has an optional AC Power adapter which is available as an accessory. Please use
only the recommended AC adapter model (not included).
It is important to set the date and time before using your blood pressure monitor, so that a
time stamp can be assigned to each record that is stored in the memory.
1. While the unit is off, press and hold the SET button for 3 seconds to enter the Settings Mode.
2. Press the MEM button to change the [YEAR].
3. When the correct year is displayed, press the SET button to confirm, and it will divert to
the [DATE] setting.
4. Repeat steps 2 and 3 to set the [MONTH] and [DAY].
5. Repeat steps 2 and 3 to set the [TIME FORMAT], then set the [HOUR] and [MINUTE].
6. Repeat steps 2 and 3 to set the [MEASUREMENT UNIT].
7. Repeat steps 2 and 3 to set the [CLOCK MODE].
8. Repeat steps 2 and 3 to set the [ALARM CLOCK]. If you set the alarm clock on, it will
divert to the alarm clock's time setting mode. After setting the alarm clock, the LCD will
display "dOnE", and then turn off.
Select the User
1. When the monitor is off , press and hold the MEM button to enter user setting mode. The
user ID will blink.
2. Then press MEM button again, select the user ID between user 1 and user 2.
3. After selecting the suitable user ID, press SET button to confirm. Then the LCD will turn off.
Tying the Cuff
1. Tie the cuff on your upper arm 2-3 cm from elbow. Position the tube off-center toward the
inner side of your arm, in line with the little finger.
2. The cuff should be snug, but not too tight. You should be able to
insert one finger between the cuff and your arm.
3. Sit comfortably with your arm resting on a flat surface.
4. Correct posture for patients with hypertension:
Bare your arm or wear tights only when starting measurement.
Sit comfortably with legs uncrossed, feet flat on the floor, back
and arm supported.
5. The center of the cuff should be leveled with the right atrium
of the heart.
6. Rest for 5 minutes before measuring. Wait at least 3 minutes between
measurements. This allows your blood circulation to recover.
7. For a meaningful comparison, try to measure under similar
conditions. For example, take daily measurements at
approximately the same time, on the same arm, or as directed
by a physician.
All manuals and user guides at all-guides.com
Battery Installation/AC Adapter
Settings
Operating the Monitor
7