Clock Mode; Lock Button - Measupro BPM-A70 Manual De Instrucciones

Taking the Measurement
1. When the monitor is off, press the START/STOP button to turn the monitor on, and start
the measurement.
2. The cuff will automatically inflate.
3. After measurement is taken the results will display on the screen.
4. The results will be saved for future memory recall.
5. To power off, press the START/STOP button, otherwise it will automatically turn off within
1 minute. Note: If you want to stop inflation during the measurement, press the START/
STOP button to escape.
1. When the monitor is off, press the MEM button to show the average value of the latest
three records. Note: If there are less than 3 records, the LCD will display the most recent
record instead.
2. Press the MEM button or SET button to scroll through the past records. Up to 60 records
will be stored under each user ID.
3. The order, date, and time will display alternatively for each reading.
4. If you want to check another user's records, press the START/STOP button to turn the
monitor off when the blood pressure monitor is in the memory inquiry mode. Press and
hold MEM button to enter into the selecting user ID mode, press MEM again to select the
user ID between user 1 and user 2, press SET button to confirm the user ID, then press
MEM button to check the selected user's measurement records.
5. To turn the blood pressure monitor off, press the START/STOP button, otherwise it will
turn off within 1 minute if there is no operation.
Note: The most recent record is shown first. Each new measurement is assigned to the first record
(1). All other records are pushed back one digit, and the last record (60) is dropped from the list.
1. To clear the memory, press and hold the MEM button for 3 seconds when the monitor is
in the memory recall mode and the display will show "User ID+ dEL ALL. " If you would
like to delete just the latest record, press the MEM button. The latest record will display.
2. Press SET to confirm deleting and the monitor will display "dEL dOnE" and then turn off.
If you just delete the latest record, it will display "dEL 001" instead.
3. Note: To exit out of delete mode without deleting any records, press START/STOP button
before pressing SET to confirm any delete commands.
4. If there is no record, the display will show ---.
1. If you set the clock mode on in the setting mode, when you turn off the blood pressure
monitor, the backlight of the LCD will turn off, the LCD will display the current time. If you
set the clock mode off in the setting mode, when you turn off the blood pressure monitor,
it will turn off completely.
2. When the backlight of the LCD is off, press any buttons to light it up. The display will
show the time.
The unnecessary keys' touch will make the blood pressure monitor turn on and waste
electricity. To avoid this, you can press the LOCK button to lock the keys if necessary.
1. Press and hold the LOCK button until the LCD displays OFF, this indicates that the touch
keys (such as MEM, START/STOP, SET) have been locked.
8
All manuals and user guides at all-guides.com
Memory Recall
Clearing the Memory

Clock Mode

Lock Button