Setting Up The Toilet; Installing Ct Model - Dometic CT 4110 Instrucciones De Montaje

CT4110, CTS4110
5.3

Setting up the toilet

A
NOTICE!
All components of the system must be installed in frost-free areas. In
freezing temperatures, there is a risk of damage caused by frost.
➤ Install the toilet according to the description for the respective model version.
➤ Set up the toilet so that it is flush to a vertical wall only.
➤ Leave enough space so that actuation of the draining slider is not restricted.
➤ For the installation, use the dimensional drawings:
– CT4110: fig. 4, page 5
– CTS4110: fig. 5, page 6
5.4

Installing CT model

The detached model CT4110 has no integrated water tank and no console. Set up
this model so that the wall behind it can accommodate the control unit of the toilet,
the electrical connections and possibly a water tank. It is best if you put a box in front
of the room wall (fig. 6, page 7).
Note here that the cassette protrudes 110 mm (4.33 in.) out of the cassette housing
(fig. 7 a, page 7).
➤ Align the toilet according to the service door.
➤ Place the housing base flush with the installation box so that there is a clean
transition and no gap.
Attaching toilet CT4110
➤ Place the toilet in the desired position.
➤ Tightly fasten the base plate with six bolts (fig. 8, page 8).
➤ Bolt the toilet housing to the wall (using a maximum of 7 bolts, not included)
(fig. 9, page 8).
➤ Place the two covers over the fastening screws in the base plate (fig. 0, page 9).
EN
Installing the toilet
21