EAS ELECTRIC EMC1850EW Manual De Instrucciones página 32

lnstallation
You shall please notice that, if you do not follow the information of this
Manual, the manufactory will not assume any responsibility far the damages
which will happen.
Before operation of the refrigerator
Before using the refrigerator, you shall please check the following contents:
1. Check whether the inside of the refrigerator is dry,
and whether the air could flow freely behind the
refrigerator.
2. lnstall 2 plastic wedges, as shown in the figure.
The plastic wedges will provide a necessary distance
between the refrigerator and the wall, in order to
allow the circulation of air. (The figure is only
provided as an example, and it is possibly not
completely the same as your product.)
3. Clean the inside of the refrigerator according to the suggestions in the
Chapter "Maintenance and Cleaning".
4. Open the refrigerator plug and insert it into a wall-type socket. When the
door of the freezing chamber is opened, relevant lamps inside it will tum on.
5. When the compressor is started, you will hear a sound. Even if the
compressor does not work, the sealed liquid and gas inside the refrigeration
system will probably produce noises, and this is normal.
6. You will probably feel that the temperatura at the front side of the
refrigerator rises. This is normal. These areas are designed to maintain warm
state, in order to avoid condensation.
Electric Connection
Connect this product to a grounding socket protected by a fuse of proper
capacity.
lmportant information:
• The connection must meet national regulations.
• After installation, the plug of power cord must be within reach.
• The specified voltage must be equal to power voltage.
• Please do not use extension cable and multiple plugs for connection.
Damaged power cord must be replaced by an electrician who has correspon-
ding qualifications.
Do not operate this product before it is properly repaired, or it will cause the
danger of electric shock!
11
L'..!cl.l[!�!!l.!!.l.ll.Ll!!!
V.1