Measuring Dc Voltage; Measuring Ac Current - Würth 0715 58 710 Traducción Del Manual De Instrucciones De Servicio Original

3.3. Measuring AC voltage
1. Set the switch to
2. Connect the red test lead to the
terminal and the black test lead to the
input terminal.
3. Apply the probe tips on the points where the
AC voltage is to be measured.
4. Read the result on the display unit
In the presence of a hazardous voltage
(>30V AC) the signal blinks on the
screen.

3.4. Measuring DC voltage

1. Set the switch to
2. Connect the red test lead to the
terminal and the black test lead to the
input terminal.
3. Apply the probe tips on the points where the
DC voltage is to be measured.
4. Read the result on the display unit
In the presence of a hazardous voltage
(>30V DC) the signal blinks on the
screen.

3.5. Measuring AC current

1. Set the switch to
2. Open the clamp by pressing the trigger.
3. Place the clamp around the conductor to be
measured and release the trigger; check that
the clamp is correctly closed.
4. Read the measurement result on the display
unit.
For safety reasons, disconnect the measur-
ing leads before performing this operation.
The clamp must be positioned around a
single conductor in a circuit, with the risk of
rendering the measurement incorrect. The
best measurement is obtained with the
conductor centred in the middle of the jaws.
input
input
17