Tabla De Contenido; Table Of Contents; Glossary Of Terms - Skil 3550 Instrucciones De Funcionamiento Y Seguridad

SM 2610031983 10-13_3550 10/29/13 11:49 AM Page 7
General Safety Rules................................................2
Additional Safety Rules..........................................3-5
Motor Specifications and Electrical Requirements....6
Table of Contents......................................................7
Glossary of Terms ....................................................7
Unpacking and Checking Contents ..........................8
Getting to Know Your Tile Saw ................................9
Assembly and Adjustments ..............................10-12
Tile Saw Blade Installation ..................................10
Top Guard Installation ........................................11
Side Extension Installation ..................................11
woRKpiece
The item on which the cutting operation is being performed.
The surfaces of a workpiece are commonly referred to as
faces, ends and edges.
aRBoR
The shaft on which a cutting tool is mounted.
cRoSScUT
A cutting or shaping operation made across the width of the
workpiece cutting the workpiece to length.
fReehaND
Performing a cut without a fence, miter gauge, fixture, hold
down or other proper device to keep the workpiece from
twisting during the cut.

Table of contents

Operation ..........................................................12-15
Filling the Water Reservoir ..................................12
Starting and Stopping ..........................................13
Making a Flat Cut ................................................13
Making a Miter Cut ..............................................14
Making a Bevel Cut ............................................14
After Use..............................................................14
Maintaining Your Tile Saw ......................................15
Troubleshooting ......................................................15

Glossary of Terms

leaDiNG eND
The end of the workpiece which, during a rip type operation, is
pushed into the cutting tool first.
RippiNG
A cutting operation along the length of the workpiece cutting
the workpiece to width.
ReVolUTioNS peR miNUTe (R.p.m.)
The number of turns completed by a spinning object in one
minute.
7.