Lincoln Electric Oerlikon CITOSTEP 255C Manual Del Usuario página 16

WARNING
Position the spool type Readi-Reel
a direction when feeding so as to be de-reeled from
bottom of the spool.
Loading the Electrode Wire

Turn the machine off.

Open the right side panel of the machine.

Unscrew the locking nut of the sleeve [24].

Load the spool with the wire on the sleeve such that
the spool turns clockwise when the wire [14] is fed into
the wire feeder.

Make sure that the spindle brake pin [27] goes into the
fitting hole on the spool.

Screw in the locking nut of the sleeve.

Put on the wire roll using the correct groove
corresponding to the wire diameter.

Free the end of the wire and cut off the bent end
making sure it has no burr.
WARNING
Sharp end of the wire can hurt.

Rotate the wire spool clockwise and thread the end of
the wire into the wire feeder as far as the Euro Socket.

Adjust force of pressure roll of the wire feeder
properly.
Adjustments of Brake Torque of Sleeve
To avoid spontaneous unrolling of the welding wire the
sleeve is fitted with a brake.
Adjustment is carried by rotation of its screw M10, which
is placed inside of the sleeve frame after unscrewing the
locking nut of the sleeve.
Figure 14.
24. Locking Nut.
40. Adjusting Screw M10.
41. Pressing Spring.
Turning the screw M10 clockwise increases the spring
tension and you can increase the brake torque.
Turning the screw M10 anticlockwise decreases the
spring tension and you can decrease the brake torque.
After finishing of adjustment, you should screw in the
locking nut again.
English
®
so that it will rotate in
24
40
41
Adjusting Pressure Roll Force
The pressure arm controls the amount of force the drive
rolls exert on the wire.
Pressure force is adjusted by turning the adjustment nut
clockwise to increase force, counterclockwise to decrease
force. Proper adjustment of pressure arm gives the best
welding performance.
If the roll pressure is too low the roll will slide on the wire.
If the roll pressure is set too high the wire may be
deformed, which will cause feeding problems in the
welding gun. The pressure force should be set properly.
Decrease the pressure force slowly until the wire just
begins to slide on the drive roll and then increase the
force slightly by turning of the adjustment nut by one turn.
Inserting Electrode Wire into Welding
Gun

Turn the welding machine off.

Depending on welding process, connect the proper
gun to the Euro Socket, the rated parameters of the
gun and of the welding machine should be matched.

Remote the nozzle from the gun and contact tip or
protection cap and contact tip. Next, straighten the gun
out flat.

Insert the wire through the guide tube, over the roller
and guide tube of Euro Socket into liner of gun. The
wire can be pushed into the liner manually for a few
centimeters, and should feed easily and without any
force.
If force is required it is likely that the wire has missed the
liner of gun.

Turn the welding machine on.

Depress the gun trigger to feed the wire through the
gun liner until the wire comes out of the threaded end.
Or the Cold Inch / Gas Purge Switch [18] can be used
– keep in "Cold Inch" position until the wire comes out
of the threaded end.

When trigger or the Cold Inch / Gas Purge Switch [18]
is released spool of wire should not unwind.

Adjust wire spool brake accordingly.

Turn the welding machine off.

Install a proper contact tip.

Depending on the welding process and the type of the
gun, install the nozzle (GMAW process, FCAW-GS
process) or protection cap (FCAW-SS process).
Take precaution to keep eyes and hands away from the
end of the gun while the wire is being come out of the
threated end.
12
WARNING
WARNING
WARNING
English