Use; Description Of The Screen; Tips For Remote Control Use - Ferroli FCM Manual De Uso

DESCRIPTION OF THE SCREEN

1) Temp: Display the set temperature . Adjust temperature via
and . No display in this area if the unit is on FAN mode .
2) Transmitting display: The icon will flash once when the si-
gnal is sent by remote controller .
Running mode: Press MODE to display current running mode .
AUTO, COOL, DRY, HEAT and FAN can be selected.
(HEAT function is invalid for cool only type unit . )
3) ON/FF: Icon is displayed when the remote controller is turned
on, or vice versa.
4) Running mode: Press MODE to display current running
mode. AUTO, COOL, DRY, HEAT and FAN can be selected.
(HEAT
function is invalid for cool only type unit . )
5) Time: Display the current set time. Press CLOCK for 5s, icon
indicating hour will flash. Press this button again, icon indicating
minute will flash. And are used to adjust the figure. Setting or
modification is effective only by pressing OK button to make
confirmation.
6) Lock: The icon will be lightened or off when pressing LOCK. In locked state, all the buttons are ineffective
except button
LOCK .
7) Time ON/OFF: In the state of time ON, icon ON will be lightened, which is the same to the state of time OFF.
Setting timer ON and OFF simultaneously, both icons ON and OFF are displayed.
8) Economic operation: This icon will be lightened or off when pressing ECO button .
9) Fan speed: Press FAN SPEED to display the current wind speed. AUTO, LOW, MED and HIGH can be se-
lected . The default state is high fan speed for the unit without medium fan speed .
NOTE: All the above icons will be displayed only when the remote controller is electrified for the first time or reset.

TIPS FOR REMOTE CONTROL USE

For a correct use of the remote control remember what follows:
1 . Remove the battery if it is not used for a long time .
2 . Point the remote control towards the signal receiver of the
indoor unit (1) when using it .
3 . The remote control signal can be received from a distance of
up to 7 meters .
4 . The emitted signal must not be hindered by any object .
5 . Handle the remote control with care .
6 . The emitted signal could be disrupted by a rapid starter lamp,
an inverter type
fluorescent lamp or a mobile phone.
7 . The remote control must not be left in a place exposed to
direct sunlight, near a heater or other source of heat.
Note Once removed as described in point 1, the batteries must
be stored in a safe place out of the reach of children .
6

USE

1
2
4
8
Fig . 3
3
5
6
7
9
Fig . 4