Ego Power+ ST1400E-ST Manual Del Operador página 11

TROUBLESHOOTING
PROBLEM CAUSE
◾
◾
String trimmer fails
◾
to start.
◾
◾
◾
◾
◾
String trimmer stops
while cutting.
◾
◾
◾
◾
◾
◾
Trimmer head will
◾
not advance line.
◾
Grass is wrapped Cutting tall grass at ground level
around trimmer head
and motor housing.
The battery pack is not attached
to the line trimmer.
No electrical contact between the
trimmer and battery.
The battery pack is depleted.
The lock off trigger is not being
moved forward before depressing
the switch trigger
The guard is not mounted on the
trimmer, resulting in an overly
long cutting line and motor
overload.
Heavy cutting line is used.
The motor shaft or trimmer head
is bound with grass.
The motor is overloaded.
The battery pack or string
trimmer is too hot.
The battery pack is disconnected
from the tool.
The battery pack is depleted.
Unbalanced after installation of
cutting line.
The motor shaft or trimmer head
is bound with grass.
There is not enough line on the
spool or the line breaks from the
eyelet.
The line is tangled.
The line is too short.
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1400E-ST
SOLUTION
◾
Attach the battery pack to the line trimmer.
◾
Remove battery, check contacts and reinstall the
battery pack.
◾
Charge the battery pack.
◾
Move the locking tongue forwards and then press
the switch trigger.
◾
Remove the battery pack and mount the guard on
the trimmer.
◾
Use recommended nylon cutting line with diameter
no greater than 2.4 mm.
◾
Stop the trimmer, remove the battery, and remove
the grass from the motor shaft and trimmer head.
◾
Remove the trimmer head from the grass. The motor
will recover to work as soon as the load is removed.
When cutting, move the trimmer head in and out of
the grass to be cut and remove no more than 20 cm
of length in a single cut.
◾
Cool the battery or string trimmer.
◾
Re-install the battery pack.
◾
Charge the battery pack.
◾
Tap the trimmer head to make the rope length
symmetrical.
◾
Stop the trimmer, remove the battery, and clean the
motor shaft and trimmer head.
◾
Remove the battery and replace the cutting line
follow "LINE REPLACEMENT" section in this
manual.
◾
Remove the battery and replace the cutting line
follow "LINE REPLACEMENT" section in this
manual.
◾
Remove the battery and replace the cutting line
follow "LINE REPLACEMENT" section in this
manual.
Cut tall grass from the top down, removing no more
than 20 cm in each pass to prevent wrapping.
EN
11