Haier MVAL007ME2AA Instrucciones De Instalación página 12

INSTALLATION INSTRUCTIONS
Gap between studs 31in (765mm)
Indoor unit 34in (850mm)
Ceiling 36in (890mm)
Decorated board 38in (950mm)
NOTE: Select an installation location according to
the piping and wiring in the ceiling, and determine the
direction of the piping before actually suspending the unit.
Hanging Unit
1. Mark the location using the cardboard template.
2. Install 3/8in threaded rods to structure using appropriate fasteners.
3. Add nuts and washers at approximate height.
4. Lift the cassette and position the threaded rods into the 4 mounting clips on each corner of the cassette unit.
5. Adjust the height of the unit so that bottom surface is recessed 1 inch from ceiling surface.
6. Using a level, adjust the nuts on the threaded rods to obtain a level reading across the bottom of the cassette unit.
7. Tighten the top nuts to lock unit into place. An additional nut on top and bottom of bracket may be added to jam against
the installation nuts to prevent them from loosening due to unit vibration.
Tighten the nut on the washer
• Check to be sure the indoor unit is level and that the
plastic drain tubes allow water to drain.
• Check the opening in the ceiling for proper size before
installing the unit frame. Frame should be secure and level.
• Fasten the screws to make the height difference between
the two sides of the indoor unit less than 0.2in(5mm).
12
AB07VMRERAB
AB09~15VMRERAB
AB18~30VMRERAB
AB36~48VMRERAB
Trim panel
Ceiling
Distance between indoor unit
and ceiling 0.8in (20mm)
Overlap between ceiling and
trim panel 1.2in (30mm)
Nut (provided on site)
Tightening (dual nuts)
[Secure Hoisting Foot]
Model H
236
257
299
341
Hanger bracket
H
Distance between indoor unit
and ceiling 0.8in (20mm)
Overlap between ceiling and
trim panel 1.2in (30mm)
Washer
Hoisting Foot
[Secure Washer Foot]
31-5000473 Rev. 0